For the continuous color control in the production line a color measurement system has been developed by Micro-Epsilon. The new system does not only recognize the saved colors according to the yes-no-principle but also determines the exact color of the components spectrophotometrically. With a precision that exceeds the human eye, and a measuring rate of 2000 Hz the system is variously used in the plastics industry.
Color recognition is necessary in the production line in order to identify quality defects early, avoid rejection and to increase the productivity of the production process. The typical color sensors measure with a precision of ΔE > 0.5. The increasing industrial requirements, however, need inspection systems with ΔE < 0.1. Currently, this is only possible with spectrophotometry. The inline color measuring system colorCONTROL ACS7000 by Micro-Epsilon meets these requirements with a color resolution of ΔE < 0.08. The measuring system has three operation modes. In the first mode – the color recognition – up to 15 colors can be saved and verified. In the second mode – the color measurement - the color values are measured and the tendency is analyzed. This mode is best suited for the plastic production because of the non-contact measurement method and the high measuring frequency of 2000 Hz. In the spectral comparison mode the reflection spectrum of the measurement object is displayed and evaluated. A wide range of color spaces (XYZ, L*a*b*, L*u*v*, L*a*b*99, L*c*h, L*c*h99), distance models (ΔE(CMC), ΔE99, ΔE94, ΔEDE2000) and standard illuminants (A, C, D65, D50, D75, E, F4, F7, F11) is available to calculate the color values.
The non-contact sensor has a measurement geometry of 30°/0°. Therefore, the self-reflection of wet or shiny surfaces has no direct influence on the measuring result. The sensor realizes a measuring distance of 50 mm and a measuring spot of 9 mm.
The color measurement system colorCONTROL ACS7000 is already used for the continuous inline color control in several areas such as the production of plastic plates and plastic bands, the examination of window frames and film extrusion.